
Page 24 Please read the instructions carefully prior to installation
DGHDP1 - DigiSender® HD Pro - Single Input Powerline AV Sender System
(EN) ENGLISH
In the unlikely event that you still can’t get the system working, please proceed with the steps below.
Step 1: Check connections, Power & Equipment
• Make sure that all power cable connections are secure and that all equipment is turned on.
• Inspect the HDMI cables and connections between the source device (e.g. HD Satellite receiver) and
DigiSender® Transmitter and the DigiSender® Receiver and receiving TV. Ensure that all HDMI connectors
are fully inserted into the correct sockets and that none of the HDMI cables are damaged in any way.
• Make sure that the source device (e.g. HD Satellite receiver) is working correctly and is output-
ting video via the HDMI socket you are using to connect it to the DigiSender® Transmitter. It is rec-
ommended that you connect the source device directly to a TV to confirm correct operation.
• Make sure that the receiving TV is working correctly and that it is set to the correct HDMI channel.
If the video is still not being displayed on the receiving TV, then please proceed to step 2 below.
Step 2: Syncing and Resetting Procedure
The Syncing and Resetting procedure is the last step in troubleshooting your product and should only be at-
tempted when all other measures have failed to resolve your problem.
The flowchart on page 25 will instruct you on how to proceed with this procedure.
Note: It is assumed that the source device (e.g. HD Satellite receiver), DigiSender® Transmitter, DigiSender® Receiver
and the receiving TV are all connected properly and turned on.
Note: It is highly recommended that you perform this procedure with both the DigiSender® Transmitter and Receiver
in the same vicinity, preferably attached to the same dual-socket mains power outlet.
Troubleshooting
Syncing and Resetting Procedure
Komentáře k této Příručce